Unplug the power supply.
Maytronics power supply not turning on.
A known exception the robo kleen power supply puts out about 30 volts a c you read correctly a c.
Unplug the blue cable from the power supply unit psu and turn it on.
We had been using it then i shut it off to clean out filter and it will not come back on.
Pair via bluetooth to your dolphin not a neighbor s.
Plug the power supply into an electrical outlet.
Check the label on your transformer for voltage output and type.
As a result that light shouldn t turn on again until the filters begin to fill up or are full.
We had been using it then i shut it off to clean out filter and it will not come back on.
Wait 30 seconds then turn it back on.
Unplug the power supply.
What about damaged filters.
Output voltage should be about 38 volts d c.
Turn the power supply off.
Are you happy with what you learned here.
The pool cleaner moves but.
Going to start a thread to see if anyone has attempted this.
See the relevant section below for more details on each program.
If no program is selected the robot will perform a single cleaning cycle.
If the outlet is receiving power.
In essence what you ve just done is zero out the sensor.
To check your maytronics diagnostic power supply use a multimeter set to 200vdc.
Open the impeller cover and check that nothing is trapped in the impeller.
Ensure the power outlet is functioning properly and that it has not tripped the breaker in the fuse box.
There may be a problem with the blue cable or the dolphin cleaner itself.
Check power to the socket and reconnect pool cleaner.
Close the unit casing turn it on and let it run.
Wait 30 seconds then turn it back on.
You can program the power supply at any time.
Take it to your local dealer for further testing or call maytronics customer service.
Turn the power supply off.
It is possible all the brains of direction and what functions to perform are controlled by the power supply box in that case it most likely would not work.
Press the on button the leds will turn on and the robot will start to operate.
Check the full filter light indicator ensuring that it s off.
After 1 min connect your smartphone to wifi.
Wait 30 seconds then turn it back on.
Check that the power supply is plugged in and turned on check that the power cable is securely connected all the way into the power supply turn the power supply off.
You ll know the app is connected if the power supply buttons are overridden in disable mode.
Open the impeller cover and check that nothing is trapped in the impeller.
