Making Your Own Gutter Guards

Mesh is also available in 4 to 8 foot sheets and they can be painted to fit the exterior of your house.

Making your own gutter guards.

Making your gutter guard. One important detail to keep in mind is that screws are needed to secure the each splashguard to your gutters. How to make your own gutter guards step 1. Don t waste money make your own diy gutter guard.

The mesh won t really need it since it will either be aluminum or galvanized. Add 2 inches to the length and width measurements to obtain the final measurement result. Measure the length and width of each gutter section with a measuring tape and mark the measurements on a notepad. The best way to make a gutter splashguard is to use a scrap piece of downspout.

They can be cut into 4 inch wide rolls using the hacksaw. You may need to buy a new section if a scrap piece is not available. Follow the steps below if you want to make your own gutter guards. Using the hacksaw cut the roll s of mesh in half making 2 rolls 4 inches wide.

You will need wire mesh which is sold in 100 foot aluminum rolls that are 8 inches wide.